The [JadeLoader] section contains parameters that affect the operation of the loading of full or partial JADE schemas by using the JADE Schema Load utility.
As the batch Schema Load utility (that is, jadloadb) and the JadeSchemaLoader application do not read parameter values from this section, you must specify all values on the command line if you do not want to use default values when loading schemas in batch mode.
Set these parameters only by using the appropriate controls in the Load Schema dialog. For details, see
If the Schema Load utility was run previously, these parameters default to the values that were used last time.
All parameters in this section are read when the Load Schema dialog is next displayed.
The [JadeLoader] section can contain the following parameters.